Attach the brackets then place the device where you want it.
Frontpoint control panel wall mount.
Get your system up and running starting with your control panel.
Close the door and mount tilt sensor on the door.
For a wall mount setup the touchscreen comes with wall mounting bracket and screws.
The screws are not provided with the panel itself and must be acquired by going to your local hardware store.
Keep note of the red battery wires and ac wires both should be going out through an oval or square hole on the back plate.
For a desktop setup the touchscreen comes with two supporting brackets.
Every frontpoint system uses the frontpoint hub and keypad as the central command center.
You can arm and disarm the system from the panel check the weather view sensor status.
They run on a 100 cellular connection with a built in wi fi backup.
The hub and keypad are pre programmed and ready to connect to your network and devices right out of the box.
Use the appropriate screws not included to mount the base plate to the wall remount the panel onto the hinge and close the panel.
The hub is the brains of your alarm system and the keypad is how you control it.
Here you ll find everything you need to set up and get familiar with your frontpoint system.
Every frontpoint system uses the frontpoint hub and keypad as the central command center.
Two included adhesives to adhere it flat against the wall or in a corner or you can place it directly on a shelf.
All frontpoint systems come with a wall mounted or tabletop controller that serves as your primary interface.
Once the control panel is fully armed and a door sensor is tripped the control panel will beep for 30 seconds.
From the frontpoint app test opening the door with the tilt sensor mounted.
Make sure the sensor is mounted with the arrow pointed towards the ceiling.
Www frontpoint com help control panel it all starts here.
Before mounting the panel to a wall.
Www frontpoint com help a b c do not mount sensor directly on a window glass break sensor.
Move the control panel to final location and send rediscover network signal.
The hub is the brains of your alarm system and the keypad is how you control it.
The control panel serves as the nerve center for your system.
Yes your control panel can be mounted on a flat wall surface using size appropriate screws.
There are no phonelines to cut the system is.
The hub and keypad are pre programmed and ready to connect to your network and devices right out of the box.
Remove the triangular shaped tabletop stand to expose all needed screw holes.
The touchscreen control panel has desktop setup and wall mounting options.
Unprecedented control is just steps away.
